Clearing Codes, Turning off SES Light

This is posted in numerous places on the www, but we may as well have it here is well. Following is the procedure to clear codes on a 3rd Gen Altima.

-Find a watch with a second hand
-Make sure car has sat for at least a minute with key off
-Turn key to 'On' position...NOT START
-Wait 3 seconds
-Fully Depress & Release gas pedal 5 times within 5 seconds(this is now 8 seconds total)
-Wait 7 seconds(this is now 15 seconds total)
-Depress gas pedal fully & hold down
-Watch 'Service Engine Soon'(SES) light
-When SES light starts to blink, release the gas pedal
-Depress gas pedal to floor and hold for 10 seconds
-Release pedal and start car
-SES light should be off now, unless there is a code thrown again.

Nice trick!

The 2nd Gen's just need a screwdriver!! Turn key till dash lights come on, Rotate screw in ECU box (next to accelerator pedal, behind a small removable panel) Clockwise about 1/2 a turn until CEL starts flashing. Step on accelerator pedal for 10 seconds. Turn screw back to original position. Turn key off. Restart motor, Code gone.